Link2Web System

Dont by a Building Automation system without trained staff to use it. Sign a Energy Manage(EM) contract including function control, monthly energy usage report, run time database, operators control over the Internet and rent of a Building Automation system for a fixed cost without investment.

Nearly all housing heating systems are today controlled according to the actual outside air temperature. This will create high heating water temperature during night hours and a lower level during daytime. Additional the temperature will be unnecessary high on days will high sunshine and to low on days with high wind velocity.

XNet system, running Zigbee, can measure room temperature in each flat and reduce energy usage by use of a special control software able to run a constant heating water temperature during 24 hours and each day adjust the temperature level depending on the average room temperature of all flats. At the same time information will be gathered to check that the heating water distribution is on the correct level to serve each flat
Learn more

TINI Web controller

Web controler between an Internet page and a Zigbee coordinator in a district heating -, a boiler - or air conditioning unit.
Learn more

XNet Coordinator

Coordinator includes software for Zigbee communication with routers, controllers, counters and several end nodes. Power supply: 3,3V DC
Learn more

XNet Controller

Controller includes software for temperature control with a fixed set point or depending on outdoor temperature and a 24V AC relay for run time control of a pump or an air-conditioning unit.
Learn more

XNet Counter

Zigbee based module. Counter input potential free contact, max 2 kHz. Power supply 3,3V DC
Learn more

XNet Endnode

Zigbee based module, input DS18B20, 1-wire. Power supply 3,3V DC or battery.

Learn more

XNet Router

Zigbee based module. Every modules radio signal penetrates normally one concrete wall. To reach further one or more routers are to be installed between Coordinator and Endnode acting as reapeters. Power supply 3,3V DC.
Learn more